15. Power Lines -- An outside antenna system should
not be located in the vicinity of overhead power
lines or other electric light or power circuits, or
where it can fall into such power lines or circuits.
When installing an outside antenna system,
extreme care should be taken to keep from
touching such power lines or circuits as contact
with them might be fetel.
16. Overloading -- Do not overload wall outlets and
extension cords as this can result in a risk of fire or
electric shock.
17. Objects and Liquids -- Never push objects of any
kind into this video unit through openings as they
may touch dangerous voltage points or short out
perts that could result in a fire or electric shock.
Never spill liquid of any kind onto the video unit.
18. Servicing -- Do not attempt to service this video
unit yourself as opening or removing covers may
expose you to dangerous voltage or other hazards,
Refer ell servicing to qualified service personnel.
19. Damage Requiring Service -- Unplug this video
unit from the wall outlet end refer servicing to
qualified service personnel under the following
conditions:
a. When the power-supply cord or plug is
damaged,
b. If any liquid has been spilled onto, or objects
have fellen into the video unit.
c. If the video unit has been exposed to rain or
water.
d. If the video unit does not operate normally by
following the operating instructions. Adjust only
those controls that are covered by the operating
instructions, as an improper adjustment of other
controls may result in damage and will often
require extensive work by e quelified technicien
to restore the video unit to its normel operetion.
e. If the video unit has been dropped or the cabinet
has been damaged.
f. When the video unit exhibits e distinct change in
performance -- this indicates a need for service.
20. Replacement Perts -- When replacement parts are
required, be sure the service technician has used
replacement parts specified by the manufacturer or
have the same characteristics es the original part.
Unauthorized substitutions may result in fire,
electric shock or other hazards.
21. Safety Check-- Upon completion of any service or
repairs to this video unit, ask the service technician
to perform safety checks to determine that the
video unit is in safe operating order.
USE & LOCATION
• TO AVOID SHOCK HAZARD ... Your Camcorder and power eul_y should not be exposed to rain or moisture.
Do not connect the power supply or operate your Camcorder If it gets wet. Your Camcorder has been designed
for outdoor use, however it is not designed to sustain direct exposure to water, rain, sleet, snow, sand, dust, or a
direct splashing from a pool or even a cup of coffee. This action could permanently damage the internal parts of
your Camcorder. Do not attempt to disassemble this unit. There are no user serviceable parts inside. Unplug
your Camcorder from the power supply before cleaning.
• DO NOT AIM YOUR CAMCORDER AT THE SUN OR OTHER BRIGHT OBJECTS
• DO NOT EXPOSE YOUR CAMCORDER TO EXTENDED HIGH TEMPERATURE ... Such as, In direct sunlight,
inside a closed car, next to a heater, etc... This action could permanently damage the internal parts of your
Camcorder.
• _/O_.ID SUt)OEN Ct'IAI_IIGES tt4 "TEMPERA'T_RE ... tf the unit _s suddent'# moved from eL cold _la.(_ to e, w_.rm
place, moisture rna.y IOrtTt On the tape a.nd inside the urt_t.
• DO NOT LEAVE YOUR CAMCORDER OR THE POWER SUPPLY TURNED ON WHEN NOT IN USE.
• STORAGE OF YOUR CAMCORDER ,,. Store and handle your Camcorder in a manner thatwillnotsubjectitto
unnecessary movement (avoid shaking and striking). Your Camcorder contains a sensitive pick-up device which
could be damaged by improper handling or storage.
CARE
• TO CLEAN YOUR CAMCORDER ... Do not use strong or abrasive detergents when cleaning your Camcorder
body,
• TO PROTECT THE LENS .. Do not touch the surface of the lens with your hand. Use a commercial camcorder
lens solution and lens paper when cleaning the lens. Improper cleaning can scratch the lens coating.
• TO PROTECT THE FINISH OF YOUR CAMCORDER .., Before handling your Cemcorder, make sure your
hands and face are free from any chemical products, such as suntan lotion, as it may damage the finish.
4
To Next Page
Loading...
Need help?
General