Panasonic PT-CW230E

Basic operations by using the remote control
ENGLISH -
33
Basic Operation
Using the AV MUTE function
button
Press the < AV MUTE> button on the remote control
to black out the image. To restore to normal, press the
< AV MUTE> button again or press any button.
The screen changes each time you press the
z
< AV MUTE> button as follows.
Note
When use the <MUTE> button to release the [
z
AV mute]
function, the mute function can not be operated at the
same time.
Using the P-TIMER button
Press the <P-TIMER> button on the remote control to
operate the [Count up] function. The Timer display “00
: 00” appears on the screen and starts to count time
(00 : 00–59 : 59).
button
Press <P-TIMER> button on the remote
control.
Note
To stop the P-timer, press the <P-TIMER> button.
z
To cancel the P-timer, press the <P-TIMER> button
z
again.
Using the LAMP button
This function allows you to select the lamp mode for
changing the brightness on the screen.
button
Press <LAMP> button on the remote
control.
Note
For details, see “Lamp Power” of "Setting" under Main
z
menu. (
Æ
page 55)
Using the D.ZOOM buttons
This function allows you to enter to the Digital zoom
+/– mode.
buttons
Press <D.ZOOM+/-> buttons on the
remote control.
Note
For details, see "Screen" of Main menu. (
z
Æ
page 47)
Controlling the volume of the
speaker
You can control the volume of the projector’s speaker
or audio output.
buttons
Press the <VOLUME+/–> buttons on the control panel
or on the remote control to adjust the volume. The
volume dialog box appears on the screen for a few
seconds.
Note
For details, see “Volume” of "Sound" under Main menu.
z
(
Æ
page 50)
Using the IMAGE button
This function allows you to select a desired image
mode of the screen.
button
Press <IMAGE> button on the remote control to select
the desired image mode among [Dynamic], [Standard],
[Real], [Cinema], [Image 1], [Image 2], [Image 3] and
[Image 4].
Note
For details, see “Image select” of Main menu.
z
(
Æ
page 43)
black out
projected image