Panasonic PT-CW230E - Screen Projection and Aspect Ratio Settings; Ceiling, Rear, and Colorboard Projection Modes; Screen Aspect Ratio Configuration

ENGLISH -
49
Settings
Screen
Ceiling
This function is used to project the image from a
ceiling-mounted projector.
Press ▲▼ to select [Ceiling] and then 1 )
press the <SELECT> button.
Press ▲▼ to change the image.2 )
When this function is set to [On], the picture will
z
be top/bottom and left/right reversed.
Rear
This function is used to project the image from rear of
the screen.
Press ▲▼ to select [Rear] and then 1 )
press the <SELECT> button.
Press ▲▼ to change the image.2 )
When this function is set to [On], the picture will
z
be left/right reversed.
Screen aspect
(PT-CW230E Only)
This function is used to project the image to a 4:3 or
16:9 projection screen.
Press ▲▼ to select [Screen aspect] 1 )
and then press the <SELECT> button.
Press ▲▼ to choose one from the 2 )
items as below.
Default(16:10)
16:10 is the aspect of the DLP
chips.
16:9
Set to a 16:9 projection screen.
4:3
Set to a 4:3 projection screen.
Attention
When the [4:3] function is selected, [Natural wide] is not
z
available in the AV screen.
When the [16:9] function is selected, [Wide (16:9)] is not
z
available in the AV screen.
Colorboard
For the image projected on a colorboard.
Press ▲▼ to select [Colorboard].1 )
Press ► or the <SELECT> button to 2 )
display the submenu.
Adjustments can be made among [Off/Red/
z
Blue/Yellow/Green/Blackboard(Green)].
Reset
To reset the adjusted data, all adjustments will return
to their previous gures.
Press ▲▼ to select [Reset] and then
press the <SELECT> button.
A conrmation box appears and then select
z
[Yes].