Panasonic PT-CW230E - Troubleshooting Advanced Issues; HDMI and Image Distortion Troubleshooting; 3 D and Glasses Troubleshooting

Troubleshooting
ENGLISH -
65
Maintenance
Problem Cause
Reference
page
Picture from a HDMI
device does not
appear or picture is
not stable.
Is the HDMI cable securely connected?
z
23
Turn off the power of the projector and the connected devices. Then turn
z
the power of the projector and the connected devices back on.
—
Isn't unsupported signal cable connected?
z
71-74
No sound is output
from a HDMI device.
Set the sound channel of the attached device to Linear PCM.
z
—
If no audio signal is output during HDMI cable connection, connect the
z
audio cable to COMPUTER 1/COMPONENT AUDIO IN terminal and set
to "Computer 1" in "Sound" of "Setting" menu.
53
The image is
distorted or runs off.
Check [PC adj.] or [Screen] and adjust them.
z
40, 47
The exclamation
mark appears on
the screen.
Your operation is invalid. Operate correctly.
z
—
3D contents appear
as 2D.
The glasses or the projector are set to 2D mode.
z
30
3D image is inverted.
(3D image is not
correct.)
3D mode is out of phase. (The data for right/left eyes is inverted.)
z
30
Image of glasses
has icker.
Outside of the recommended viewing zone of the glasses.
z
30
Glasses does not
turn on.
The battery of the glasses is exhausted.
z
The projector is not set to 3D mode.
z
30
Note
If the problem persists, after conrming the contents of the table, please consult your dealer.
z