16 –
ENGLISH
Location and function of each part (continued)
1
REMOTE1 lN/OUT terminal ････････････ (p. 18)
When two or more main units are used in the
system, they can be connected and controlled
with a wired remote control cable (M3 jack).
2
REMOTE2 IN terminal ････････････････ (p. 108)
The user can remotely control the main unit by
using an external control circuit to this terminal
(D-SUB 9-pin female).
3
SERIAL IN terminal････ (pp. 26-27, 78, 104-107)
RS-232C compliant input terminal (switching
necessary) to connect a PC and to externally
control the main unit (D-SUB 9-pin female).
4
SERIAL IN terminal････ (pp. 26-27, 78, 104-107)
RS-422 compliant input terminal (switching
necessary) to connect a PC and to externally
control the main unit (D-SUB 9-pin female).
5
SERIAL OUT terminal ････････(pp. 27, 104-107)
RS-422 compliant output terminal (switching
necessary) to loop through signals from the Serial
Input terminals (D-SUB 9-pin male).
6
LAN terminal (10BASE-T/100BASE-TX)
･･･････････････････････････････ (pp. 26-27, 91)
The projector can be connected to a network and
controlled through it’s onboard web page.
7
VIDEO IN terminal･････････････････････ (p. 26)
An input terminal for video signals. (BNC)
8
VIDEO OUT terminal ･･････････････････ (p. 26)
An output terminal (active through) for video
signals. (BNC)
9
S-VIDEO IN terminal ･･････････････････ (p. 26)
An input terminal for S-video signals (Mini DIN
4-pin). This terminal complies with S1 signals
and automatically toggles between 16:9 and 4:3
according to the size of input signals.
j
RGB (YPBPR) 1 IN terminal ･････････ (pp. 26, 27)
A terminal to input RGB or YPBPR signals (3, 4 or
5-wire BNC).
k
RGB2 IN terminal ･････････････････････ (p. 27)
A terminal to input RGB or YPBPR signals (D-SUB
15-pin female).
l
DVI-D IN terminal ･････････････････ (pp. 26, 27)
An input terminal for single-link DVI-D signals.
Connection terminals
1
7
2
89 jk l
3456
To Next Page
Loading...
