48 –
ENGLISH
Basic operations using the remote control (continued)
Changing the picture
aspect ratio
You can toggle through an appropriate set of aspect
ratios for a given input signal.
Press ASPECT on the remote 1.
control.
The setting will change as follows each time •
ASPECT is pressed.
VID AUTO (PRI.) DEFAULT
S1 AUTO THROUGH
VID AUTO 16:9
HV FIT 4:3
V FIT H FIT
Note
Some aspect ratios may not be available for •
selection depending on the input signal. Refer to
“Adjusting the aspect ratio” for details. (p. 59)
To Next Page
Loading...
