ENGLISH
– 33
Getting Started
Connecting signals to the DVI-D input module
DVI Module
ET-MD77DV
DVI-D IN LAN
DVI-D input module (optional)
ET-MD77DV
DVI-D signal LAN terminal
*1
(10BASE-T/100BASE-TX)
DVD player or high-vision
video deck equipped with
DVD/HDMI terminal
PC with DVI output
Pin assignments and signal names of DVI-D input •
terminal are listed in the table at right.
Pin
No.
Signal
Pin
No.
Signal
1
T.M.D.S data 2–
m
18
9p
qx
Outside view
2
T.M.D.S data 2+
n
+5V
3
T.M.D.S data 2 / 4
shield
o
Ground
p
Hot plug detection
4
q
T.M.D.S data 0-
5r
T.M.D.S data 0+
6
DDC clock
s
T.M.D.S data 0 / 5
shield
7
DDC data
8t
9
T.M.D.S data 1–
u
j
T.M.D.S data 1+
v
T.M.D.S clock shield
k
T.M.D.S data 1 / 3
shield
w
T.M.D.S clock+
lx
T.M.D.S clock–
Note
The DVI-D signal input module supports only a single link.•
The HDMI-DVI-D conversion cable is required to connect an HDMI-compliant device.•
When using the DVI-D input, EDID settings may be required for the connected device. (pp. 71, 72)•
It is possible to connect the DVI-D input module with an HDMI- or DVI-D-compliant device, but with some •
devices the images may not appear or other problems may be encountered in operation.
*1: The LAN terminal present on the optional input card cannot be used. Use the LAN terminal that is provided as
standard with the projector.
To Next Page
Loading...
