10.11. Removal of WL-P.C.Board
(1) Remove the upper case according to the section 10.2. "Removal
of Upper Case".
(2) Unscrew the 3 screws and remove the WL-P.C.Board.
Note:
·
The WL-P.C.Board is connected onto the A-P.C.Board
with the connector. Work carefully when removing it.
10.12. Removal of Ballast-1 and Ballast-2 Modules
(1) Remove the A-P.C.Board block according to the steps 1 through
3 in the section 10.3. "Removal of A-P.C.Board".
(2) Loosen the 3 screws fixing the lamp unit until they idle and
remove the lamp unit 1.
(3) Unscrew the 1 screw and release the terminal for lamp unit 1.
(4) Open the lamp socket holder and separate the socket and the
plug for the connection.
31
PT-DZ6710U / PT-DZ6710E / PT-DZ6700U / PT-DZ6700E / PT-DW6300US / PT-DW6300ES / PT-D6000US / PT-D6000ES
To Next Page
Loading...
