10.16. Removal of Analysis/Synthesis Block
(1) Remove the A-P.C.Board block according to the steps 1 through
3 in the section 10.3. "Removal of A-P.C.Board".
(2) Loosen the each of 3 screws until they idle and remove the lamp
units 1 and 2.
(3) Unscrew the 1 screw and release the terminal for lamp unit 1.
(4) Open the lamp socket holder and separate the socket and the
plug for the connection.
(5) Unscrew the 4 screws and release the block of intake air duct
and ACF drive unit.
(6) Unscrew the 7 screws and remove the Analysis/Synthesis block.
35
PT-DZ6710U / PT-DZ6710E / PT-DZ6700U / PT-DZ6700E / PT-DW6300US / PT-DW6300ES / PT-D6000US / PT-D6000ES
To Next Page
Loading...
