Chapter 3 Basic Operations — Projecting
ENGLISH - 63
f When the main power is switched off during shift adjustment, a lens calibration error screen will be displayed during the next shift
adjustment. Execute the [PROJECTOR SETUP] menu → [LENS CALIBRATION].
f When the lens calibration error is displayed even though [LENS CALIBRATION] was executed, ask your dealer to repair the unit.
Adjusting the lens position and focus when the xed-focus lens (Model No.:
ET-DLE030) is used
After attaching the projection lens, adjust the lens position and the focus with the projector correctly installed
against the screen.
The focus balance between the center and periphery of the projected image will differ depending on the size of
the projected image when the xed-focus lens (Model No.: ET-DLE030) is attached. Adjust the focus balance of
the periphery with the xed-focus lens (Model No.: ET-DLE030) as necessary.
1) Move the lens to the ET-DLE030 standard lens position.
f While the shift adjustment screen is displayed, press the <DEFAULT> button on the remote control to
display the [HOME POSITION] screen. Select [DLE030] to move the lens to the standard lens position.
Refer to “Setting the lens position” (x page 63) for details.
2) Adjust the focus at the center of projected image.
f For the steps to adjust the focus, refer to “Adjusting the focus, zoom, and shift” (x page 62).
3) Turn the periphery focus adjustment ring by hand to adjust the focus in the periphery of the screen.
Periphery focus adjustment ring
4) Check the focus at the center of the image again and make fine adjustments.
Note
f The projected image size and scale shown on the periphery focus adjustment ring are an approximate guide.
Setting the lens position
To move the lens position to the home position or the standard lens position, perform the following procedure.
1) Press the <DEFAULT> button on the remote control while the shift adjustment screen is displayed.
f The [HOME POSITION] screen is displayed.
LENS
HOME POSITION
EXECUTE
CANCEL
ENTER
MENU
NORMAL
CHANGE
2) Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
Moves the lens to the home position.
Select this item when replacing or removing the projection lens. Select this item when the xed-focus
lens (Model No.: ET-DLE055) is used for projection.
[DLE030]
Moves the lens to the ET-DLE030 standard lens position.
Select this item when the xed-focus lens (Model No.: ET-DLE030) is used for projection.
3) Press the <ENTER> button.
f [PROGRESS] is displayed in the [HOME POSITION] screen, and the lens position returns to the home
position or the standard lens position.
To Next Page
Loading...
