Chapter 2 Getting Started — Setting up
ENGLISH - 31
Setting up
Installation mode
There are four ways to set up the projector. Set the [PROJECTOR SETUP] menu → [PROJECTION METHOD]
(x page 111) depending on the installation mode. Set [COOLING CONDITION] to [AUTO]. Using the projector
with [COOLING CONDITION] set incorrectly may shorten the life of the lamp.
Mounting on the ceiling and projecting forward Setting on a desk/oor and projecting from rear
(Using the translucent screen)
Menu item Method Menu item Method
[PROJECTION METHOD] [FRONT/CEILING] [PROJECTION METHOD] [REAR/FLOOR]
[COOLING CONDITION] [AUTO] [COOLING CONDITION] [AUTO]
Mounting on the ceiling and projecting from rear
(Using the translucent screen)
Setting on a desk/oor and projecting forward
Menu item Method Menu item Method
[PROJECTION METHOD] [REAR/CEILING] [PROJECTION METHOD] [FRONT/FLOOR]
[COOLING CONDITION] [AUTO] [COOLING CONDITION] [AUTO]
To Next Page
Loading...
