Panasonic PT-DZ780

Chapter 4 Settings — [DISPLAY OPTION] menu
108 - ENGLISH
Note
f [UNIFORMITY] can be set for each [LAMP SELECT] setting.
f The [UNIFORMITY] settings are not reset to the factory defaults even when [ALL USER DATA] is executed from the [PROJECTOR SETUP]
menu → [INITIALIZE] (x page 126).
[SHUTTER SETTING]
Enable/disable the shutter function automatically (shutter: closed/open) when the power is turned on.
Setting [STARTUP]
1) Press as to select [SHUTTER SETTING].
2) Press the <ENTER> button.
f The [SHUTTER SETTING] screen is displayed.
3) Press as to select [STARTUP].
4) Press qw to switch the item.
[OPEN] Starts projection with the shutter function disabled (shutter: open) when the power is turned on.
[CLOSE] Starts projection with the shutter function enabled (shutter: closed) when the power is turned on.
Setting [SHUT-OFF]
1) Press as to select [SHUTTER SETTING].
2) Press the <ENTER> button.
f The [SHUTTER SETTING] screen is displayed.
3) Press as to select [SHUT-OFF].
4) Press qw to switch the item.
[KEEP CURRENT STATE] When the projector is switched off, the projector turns into standby with the shutter status left as is.
[OPEN] When the projector is switched off, the projector turns into standby with the shutter left opened.
[CLOSE] When the projector is switched off, the projector turns into standby with the shutter left closed.
[FREEZE]
Freeze the projected image temporarily regardless of the playback of the external device.
1) Press as to select [FREEZE].
2) Press the <ENTER> button.
f Press the <MENU> button to release.
Note
f [FREEZE] is displayed on the screen while freezing the image.
f The image may momentarily disrupted before stopping when the image is stopped by operating [FREEZE] while the moving image is
projecting.
[WAVEFORM MONITOR]
Use the input signals from a connected external device to display in a waveform. Check whether video output
(luminance) signal level is within the recommended range for the projector and adjust.
1) Press as to select [WAVEFORM MONITOR].
2) Press qw to switch the item.
[OFF] Does not display the waveform monitor.
[ON] Displays the waveform monitor.
3) Press the <MENU> button two times to clear.