Panasonic PT-EZ770T

INF-26
SECTION 1 SERVICE INFORMATION
5. 4. Initialization for control device password
Take the procedure below to restore the factory default password (AAAA).
1.Pressthe[AUTOSETUP]buttonontheremotecontrolorthe[INPUTSELECT]buttonandthe[▲]buttononthecontrol
panel of projector at the same time for more than 2 seconds while the control device password input request menu is dis-
played on the screen.
2.Pressthe[▼]buttonformorethan2seconds.
The password will be initialized.
Attention
• After washing the air filter unit, dry it thoroughly before attaching it back to the projector. Attaching a wet unit will cause an
electric shock or malfunction.
• Do not disassemble the air filter unit.
• Make sure that the air filter unit is properly attached before using the projector. If it is not attached, the projector will suck in
dirt and dust causing a malfunction.
Note
•Ifyouusetheprojectorwithoutattachingtheairfilterunit,thefilterindicator<FILTER>flashesinredandthemessageap-
pears on the projected image for approximately 30 seconds.
•ReplacetheairfilterunitwiththenewoptionalReplacementFilterUnitifitisdamagedorifthedirtdoesnotcomeoffeven
after washing.
• Air filter replacement is recommended after cleaning the unit two times.
• The dust-proof properties may be reduced after each cleaning.