Panasonic PT-EZ770T

INF-28
SECTION 1 SERVICE INFORMATION
6. 2. System log data acquisition method
6. 2. 1. Equipment to be used
1. Computer : Use it for the collected log data.
2.Communicationcable:D-sub9pin(male/femaleRS-232Cstraight)
3. Service Software : [DataLogBackup.exe] Service software is downloaded from the projector service homepage.
6. 2. 2. Connection Preparations
1. Confirm and make a note of "Projector ID" and "Transmission
speed", "Parity setting".
2. Connect the serial terminals on the projector and the PC by
using a communication cable.
Attention:
Please setup the computer not into standby or shutdown
during the working.
6. 2. 3. Acquisition of log data
1.Switchtheprojectorto"Normal-Standby"mode(POWERindicatorisLightinginred).
2. Start up service software [DataLogBackup.exe] with a computer.
3.Select"Option"→"Setting"andsetupSerialPortofthecomputer,BaudRateandParity.
4. Select a model number and ID.
SERIALIN
Computer
Projector
Serialcable(RS-232C)