Panasonic PT-EZ770T

ADJ-7
SECTION 3 ADJUSTMENTS
1. 4. 4. Restore the backup EEPROM data (after board replacing)
1.Settheprojectorto"Normal-Standby"mode(POWERindicatorisLightinginred).
2. Start up service software "DataLogBackup.exe" with a computer.
3.Select"Option"-"Setting"andsetSerialPortofthecomputer,BaudRateandParity.
4. Select a model number and ID.
5.1)Choose"Backup(EEPROM)"tab.
 2)Checkthe"REPLACEA-PWB"of"COPYMODE"item.
 3)Clickthe[WRITEEEPROM]button.
6. Select the backup file and click the [OPEN(O)] button.
7. When the progress bar reaches the right-side end, the data writing process is complete.
 Select"File"-"Quit"toquitthesoftware.
8.Afterfinishingthedatawriting,turnthePOWERswitchoffandon,thenconfirmthattheprojectoroperatescorrectly.