8. Unscrew the 3 screws and remove the block of Analysis
Block, LCD Block and Projection Lens.
9. Unscrew the 4 screws A and remove the projection lens
with the shift mechanism.
10. Unscrew the 2 screws B and remove the LCD block (the
analysis block remains).
7.18. Removal of LCD Block
1. Remove the A-P.C.Board block according to the steps 1
through 4 in the section 7.3. "Removal of A-P.C.Board".
2. Unscrew the 2 screws and remove the LCD block.
Note:
·
Be careful not to touch the surface of prism and LCD
panel.
7.19. Replacement of LCD Panel (B)
1. Remove the LCD block according to the section 7.18.
"Removal of LCD Block".
Note:
·
Be careful not to touch the surface of prism and LCD
panel.
2. Cut the 4 LCD panel installation spindles at the position A
and remove the LCD panel.
3. Cut the 4 LCD panel installation spindles at the position B
and remove them.
Notes:
·
Work carefully not to apply external force around the
spindle part by using a cutter, cutting nipper or the
like for cutting the spindle.
·
Adjust the height after the spindle is cut to 1 mm or
less.
4. Attach the base plate with 4 screws.
5. Tighten the 2 screws temporarily just until new LCD panel
(with the panel attachment and panel adjuster) can be
18
PT-F100NTU / PT-F100NTE / PT-F100NTEA / PT-F100U / PT-F100E / PT-F100EA
To Next Page
Loading...
