Panasonic PT-MZ10K

Chapter 4 Settings — [DISPLAY OPTION] menu
ENGLISH - 109
Note
f The data for plug and play will change when the setting is changed. Refer to “List of compatible signals” (x page 232) for details on a
resolution that supports plug and play.
Setting [EDID MODE] in [DVI-D IN]
1) Press as to select [DVI-D IN].
2) Press the <ENTER> button.
f The [DVI-D IN] screen is displayed.
3) Press as to select [EDID MODE].
4) Press the <ENTER> button.
f The [DVI-D EDID MODE] screen is displayed.
5) Press qw to switch the item.
f The items will switch each time you press the button.
[DEFAULT] Standard setting.
[SCREEN FIT] Changes the EDID data according to the [SCREEN FORMAT] setting.
[USER] Sets the [RESOLUTION] and [VERTICAL SCAN FREQUENCY] items as EDID.
f Proceed to Step 10) when [DEFAULT] or [SCREEN FIT] is selected.
6) Press the <ENTER> button.
f The [RESOLUTION] screen is displayed.
7) Press asqw to select [RESOLUTION].
f Select [1024x768p], [1280x720p], [1280x800p], [1280x1024p], [1366x768p], [1400x1050p], [1440x900p],
[1600x900p], [1600x1200p], [1680x1050p], [1920x1080p], [1920x1080i], or [1920x1200p].
8) Press the <ENTER> button.
f The [VERTICAL SCAN FREQUENCY] screen is displayed.
9) Press qw to select [VERTICAL SCAN FREQUENCY].
f Select [60Hz], [50Hz], [30Hz], [25Hz], or [24Hz] when [1920x1080p] is selected for [RESOLUTION].
f Select [60Hz], [50Hz], or [48Hz] when [1920x1080i] is selected for [RESOLUTION].
f Select [60Hz] or [50Hz] when anything other than following is selected for [RESOLUTION].
g [1920x1080p], [1920x1080i]
10) Press the <ENTER> button.
f The conrmation screen is displayed.
11) Press qw to select [OK], and press the <ENTER> button.
Note
f The setting details are displayed in [RESOLUTION] and [VERTICAL SCAN FREQUENCY] of [EDID STATUS].
f Setting of the resolution and the vertical scanning frequency may be necessary on the computer or video device in use.
f The computer, video device, or projector in use may require the power to be turned off and on again after setting.
f The output with the set resolution or vertical scanning frequency may not be possible depending on the computer or video device in use.
[SDI IN]
Set this item in accordance with the signal input to the <SDI IN> terminal.
Setting [RESOLUTION]
1) Press as to select [SDI IN].
2) Press the <ENTER> button.
f The [SDI IN] screen is displayed.
3) Press as to select [RESOLUTION], and press the <ENTER> button.
f The [RESOLUTION] screen is displayed.