Panasonic PT-MZ10K

Chapter 4 Settings — [DISPLAY OPTION] menu
116 - ENGLISH
[IMAGE ROTATION]
Set whether to rotate the input image when projecting.
1) Press as to select [IMAGE ROTATION].
2) Press qw to select an item.
f The items will switch each time you press the button.
[OFF] Projects the input image without rotating.
[CLOCKWISE] Rotates the input image by 90° clockwise and project it.
[COUNTERCLOCKWISE] Rotates the input image by 90° counterclockwise and project it.
Note
f The on-screen display direction does not change even when this item is set to anything other than [OFF]. Set the [DISPLAY OPTION] menu
→ [ON-SCREEN DISPLAY] → [OSD ROTATION] as required.
[BACK COLOR]
Set the display of the screen when a signal is not input.
1) Press as to select [BACK COLOR].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[BLUE] Displays blue in the entire screen.
[BLACK] Displays black in the entire screen.
[DEFAULT LOGO] Displays the Panasonic logo in the screen.
[USER LOGO] Displays the image registered by the user in the screen.
Note
f The [BACK COLOR] setting item is common with the following menu item.
g The [PROJECTOR SETUP] menu → [NO SIGNAL SETTING] → [BACK COLOR]
f To create and register the [USER LOGO] image, use “Logo Transfer Software”.
The software can be downloaded from the Panasonic website (https://panasonic.net/cns/projector/).
[STARTUP LOGO]
Set the logo display when the power is turned on.
1) Press as to select [STARTUP LOGO].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[DEFAULT LOGO] Displays the Panasonic logo.
[USER LOGO] Displays the image registered by the user.
[NONE] Disables the startup logo display.
Note
f When [USER LOGO] is selected, the display of the startup logo will be kept for approximately 15 seconds.
f To create and register the [USER LOGO] image, use “Logo Transfer Software”.
The software can be downloaded from the Panasonic website (https://panasonic.net/cns/projector/).
f When the [PROJECTOR SETUP] menu → [QUICK STARTUP] is set to [ON], the startup logo is not displayed when the projection is started
before the specied time has elapsed after going into the standby mode.
The specied time is the time set in the [PROJECTOR SETUP] menu → [QUICK STARTUP] → [VALID PERIOD].
[UNIFORMITY]
Correct the brightness unevenness and color unevenness of the entire screen.
1) Press as to select [UNIFORMITY].
2) Press qw to select an item.
f The items will switch each time you press the button.