Panasonic PT-MZ10K

Chapter 7 Appendix — Technical information
222 - ENGLISH
r COLOR, TINT
Performance Parameter Default value
No operation 0-31
0
Factory default setting 32-63
- 31 64-65
… …
0 128-129
… …
+31 190-191
No operation 192-255
r RASTER PATTERN
Performance Parameter Default value
No operation 0-15
0
OFF 16-31
WHITE 32-47
YELLOW 48-63
CYAN 64-79
GREEN 80-95
MAGENTA 96-111
RED 112-127
BLUE 128-143
BLACK 144-159
USER LOGO 160-175
No operation 176-255
r ENABLE/DISABLE
Operation for all channels is not accepted when set to “Disable”.
Performance Parameter Default value
Disable 0-127
0
Enable 128-255
Note
f If the projector is operated using the remote control or the control panel, or by the control command while controlling the projector using the
Art-Net function, the setting of the DMX controller or computer application may be different from the projector status. To reect the controls
of all channels to the projector, set “ENABLE/DISABLE” of channel 11 to “Disable” and then back to “Enable”.
f To create and register the USER LOGO image, use “Logo Transfer Software”.
The software can be downloaded from the Panasonic website (https://panasonic.net/cns/projector/).
Control commands via LAN
The projector can be controlled via the <DIGITAL LINK> terminal or the <LAN> terminal by using the control
command format via the <SERIAL/MULTI PROJECTOR SYNC IN> terminal.
For examples of the available commands, refer to “Control command” (x page 229).
When web control administrator rights password is set (Protect mode)
Connecting
1) Obtain the IP address and port number (Initial set value = 1024) of the projector and request a
connection to the projector.
f You can obtain both the IP address and the port number from the menu screen of the projector.
IP address
Obtain from the [NETWORK] menu → [NETWORK STATUS].
Port number
Obtain from the [NETWORK] menu → [NETWORK CONTROL] → [COMMAND PORT].