Chapter 4 Settings — [PICTURE] menu
ENGLISH - 87
[DEFAULT PICTURE MODE]
Set the picture mode to be applied when a new signal is input. The setting in the [PICTURE] menu → [PICTURE
MODE] will switch according to the setting.
1) Press as to select [DEFAULT PICTURE MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO]
Set [PICTURE MODE] to [GRAPHIC] when a still image signal is input or [STANDARD] when a
moving image signal is input.
[STANDARD] Set [PICTURE MODE] to [STANDARD].
[CINEMA] Set [PICTURE MODE] to [CINEMA].
[NATURAL] Set [PICTURE MODE] to [NATURAL].
[REC709] Set [PICTURE MODE] to [REC709].
[DICOM SIM.] Set [PICTURE MODE] to [DICOM SIM.].
[DYNAMIC] Set [PICTURE MODE] to [DYNAMIC].
[GRAPHIC] Set [PICTURE MODE] to [GRAPHIC].
Note
f The following are the conditions where the setting in the [PICTURE] menu → [PICTURE MODE] is switched to the picture mode set in
[DEFAULT PICTURE MODE].
g When a new signal is input
g When the deleted signal is input again after the registered signal has been deleted
g When the <DEFAULT> button is pressed while the [PICTURE] menu → [PICTURE MODE] is selected
g When there is no input signal
To Next Page
Loading...
