Chapter 4 Settings — [PROJECTOR SETUP] menu
146 - ENGLISH
[INPUT] Currently selected input terminal
[SIGNAL NAME] Input signal name
[AC VOLTAGE] Input supply voltage
[INTAKE AIR TEMP.] Intake air temperature of the projector
[EXHAUST AIR TEMP.] Exhaust air temperature of the projector
[SHUTTER] Status of the shutter ([CLOSE]: Shutter function enabled; [OPEN]: Shutter function disabled)
[OSD] Status of the on-screen display function ([ON]: Display; [OFF]: Hide)
[IP ADDRESS] IP address of the wired LAN
6) Press qw to switch the setting.
f The items will switch each time you press the button.
[ON] Displays the items in the information monitor.
[OFF] Does not display the items in the information monitor.
f Repeat Steps 5) to 6) until the desired display items are set.
Note
f This can also be set with operation in the information monitor. For details, refer to “Using the information monitor function” (x page 189).
Setting the direction to display
Set the direction of the text to display in the information monitor.
1) Press as to select [INFO MONITOR SETTING].
2) Press the <ENTER> button.
f The [INFO MONITOR SETTING] screen is displayed.
3) Press as to select [DIRECTION].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO]
Detects the orientation of the projector by the built-in angle sensor, and automatically sets the
direction of the text displayed in the information monitor. Set [AUTO] normally.
[NORMAL] Select this item when installing the projector on a desk, etc.
[FLIPPED]
Select this item when installing the projector with the top surface of the projector facing down such as
ceiling attachment.
Displays the text inverted upside down from when [NORMAL] is set.
Note
f This can also be set with operation in the information monitor. For details, refer to “Using the information monitor function” (x page 189).
Setting the brightness of the information monitor
Set the brightness of the information monitor.
1) Press as to select [INFO MONITOR SETTING].
2) Press the <ENTER> button.
f The [INFO MONITOR SETTING] screen is displayed.
3) Press as to select [BRIGHTNESS].
4) Press qw to adjust the level.
Operation Adjustment Range of adjustment
Press w.
The information monitor becomes bright.
30 % - 100 %
(Factory default setting: 100 %)
Press q.
The information monitor becomes dark.
Note
f [BRIGHTNESS] is adjusted in increments of 10.
f This can also be set with operation in the information monitor. For details, refer to “Using the information monitor function” (x page 189).
To Next Page
Loading...
