Chapter 6 Maintenance — Maintenance/replacement
210 - ENGLISH
Attaching the air lter unit
1) Attach the air filter unit to the projector.
f Attach the air lter unit in the reverse procedure of Step 3) in “Removing the air lter unit” (x page 209).
f Push in the air lter unit all the way in until it clicks.
2) Attach the air filter cover.
f Close the air lter cover in the reverse procedure of Step 2) in “Removing the air lter unit” (x page 209),
and press it in all the way until it clicks.
f Securely tighten the air lter cover xing screw (x 1) using a Phillips screwdriver.
Resetting the lter counter
1) Turn on the power of the projector.
2) Press the <MENU> button on the remote control or control panel.
f The [MAIN MENU] screen is displayed.
3) Press as to select [PROJECTOR SETUP].
4) Press the <ENTER> button.
f The [PROJECTOR SETUP] screen is displayed.
5) Press as to select [FILTER COUNTER].
6) Press the <ENTER> button.
f The [FILTER COUNTER] screen is displayed.
7) Press as to select [FILTER COUNTER RESET], and press the <ENTER> button.
f The conrmation screen is displayed.
8) Press qw to select [OK], and press the <ENTER> button.
f Display of [FILTER COUNTER] will change to [0 H].
Attention
f After washing the air lter unit, dry it thoroughly before attaching it back to the projector. Attaching a wet unit will cause an electric shock or
malfunction.
f Do not disassemble the air lter unit.
f Make sure that the air lter unit is properly attached before using the projector. If it is not attached, the projector will suck in dirt and dust
causing a malfunction.
f Do not insert object from the hole of the intake vent. Doing so may cause damage.
Note
f When the projector is used without resetting the lter counter, the actual lter runtime (counter numeric value) will not be able to be
conrmed.
f When the projector is used without attaching the air lter unit, the lter indicator <FILTER> will blink in red, and a message is displayed on
the projected image for approximately 30 seconds.
f When the air lter unit is damaged or dirt does not come off even if it is washed, replace with the new optional Replacement Filter Unit
(Model No.: ET-RFM100).
f Replacement to a new air lter unit is recommended after washing it twice.
f The dust-proof properties may be reduced after each cleaning.
f The replacement cycle of the air lter unit varies greatly depending on the usage environment.
To Next Page
Loading...
