Panasonic PT-MZ770

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 123
f [INCOMPLETE] is displayed when the lens calibration was not executed correctly.
f Pressing the <FOCUS> button on the remote control for three seconds or longer will also display the conrmation screen for lens calibration
execution.
[AUDIO SETTING]
Set audio functions in detail.
Adjusting the volume
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [VOLUME].
4) Press qw to adjust the level.
Operation Adjustment Range of adjustment
Press w.
Increases the volume.
0 - 63
Press q.
Decreases the volume.
Adjusting the left to right audio balance
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [BALANCE].
4) Press qw to adjust the level.
Operation Adjustment Range of adjustment
Press w.
Increases the volume on the right.
L16 - R16
Press q.
Increases the volume on the left.
Setting the audio output of the built-in speaker
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [BUILT-IN SP].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[ON]
Outputs the audio from the built-in speaker.
[OFF]
Does not output the audio from the built-in speaker.
Note
f When [BUILT-IN SP] is set to [ON], audio is output from the built-in speaker even when a cable is connected to the <VARIABLE AUDIO
OUT> terminal. To not output audio from the built-in speaker and output the audio from the external audio device connected to the
<VARIABLE AUDIO OUT> terminal, set [BUILT-IN SP] to [OFF].
Setting audio output in the standby mode
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.