Panasonic PT-MZ770

Chapter 4 Settings — [NETWORK/USB] menu
146 - ENGLISH
[SUBNET MASK]
255.255.255.0
[DEFAULT GATEWAY]
192.168.11.1
[DNS1]/[DNS2]
(Blank)
[PROJECTOR NAME]
Name of the projector can be changed. Enter if a host name is required when using the DHCP server, etc.
1) Press as to select [PROJECTOR NAME].
2) Press the <ENTER> button.
f The [PROJECTOR NAME CHANGE] screen is displayed.
3) Press asqw to select the character, and press the <ENTER> button to enter the character.
f Up to 16 characters can be entered.
4) Once the entry of the projector name is completed, press asqw to select [OK], and press the
<ENTER> button.
f To cancel, select [CANCEL].
Note
f The factory default of the projector name is “Namexxxx”. xxxx is the last four digits of the network ID. The network ID is a xed value
assigned to each product. The network ID can be conrmed in the standby screen projected when switched to Panasonic APPLICATION
input.
[NETWORK CONTROL]
Set up the control method of the network.
1) Press as to select [NETWORK CONTROL].
2) Press the <ENTER> button.
f The [NETWORK CONTROL] screen is displayed.
3) Press as to select an item, and press qw to change the setting.
[WEB CONTROL]
Set to [ON] to control with the web browser.
[PJLink CONTROL]
Set to [ON] to control with the PJLink protocol.
[PJLink NOTIFICATION]
Set to [ON] to use the PJLink notication function.
f The [PJLink NOTIFICATION] screen is displayed when set to [ON] and the <ENTER> button is
pressed. Set the IP address of the computer to notify the status of the projector in [NOTIFIED IP
ADDRESS 1], [NOTIFIED IP ADDRESS 2].
[COMMAND CONTROL]
Set to [ON] to control with the control command format (x page 217) for the <SERIAL IN> terminal.
Refer to “Control commands via LAN” (x page 212).
[COMMAND PORT]
Set the port number used for command control.
[Crestron Connected(TM)]
Set to [ON] to control with Crestron Connected of Crestron Electronics, Inc.
[AMX D.D.]
Set to [ON] to control with the controller of AMX Corporation.
Setting this function to [ON] enables detection through “AMX Device Discovery”. For details, visit the
website of AMX Corporation.
URL http://www.amx.com/
[EXTRON XTP]
Set to [ON] when connecting the “XTP transmitter” of Extron Electronics to the <DIGITAL LINK/LAN>
terminal.
The [EXTRON XTP] setting must be set to [OFF] when connecting the optional DIGITAL LINK output
supported device (Model No.: ET-YFB100G, ET-YFB200G).
For details of the “XTP transmitter”, visit the website of Extron Electronics.
URL http://www.extron.com/
4) Press as to select [STORE], and press the <ENTER> button.
f The conrmation screen is displayed.
5) Press qw to select [OK], and press the <ENTER> button.
[MEMORY VIEWER]
Set the operation of the Memory Viewer.
1) Press as to select [MEMORY VIEWER].