Panasonic PT-MZ770

Chapter 4 Settings — [POSITION] menu
ENGLISH - 93
2) Press the <ENTER> button.
f The [ZOOM] screen is displayed.
3) Press as to select [MODE].
4) Press qw to switch the item.
[INTERNAL]
Enlarges the size within the aspect range set with [SCREEN FORMAT].
[FULL]
Enlarges or reduces the size using the entire display area set with [SCREEN FORMAT].
5) Press as to select [INTERLOCKED].
6) Press qw to switch the item.
[OFF]
Sets the [VERTICAL] and [HORIZONTAL] zoom ratio.
[ON]
Uses [BOTH] to set zoom ratio. Image can be enlarged or reduced vertically and horizontally at the
same magnication.
7) Press as to select [VERTICAL] or [HORIZONTAL].
f If [ON] is selected, select [BOTH].
8) Press qw to adjust.
Note
f When the [POSITION] menu → [ASPECT] is set to anything other than [NORMAL], [MODE] is not displayed.
f [ZOOM] cannot be adjusted when the input is MEMORY VIEWER, Panasonic APPLICATION, or MIRRORING.
[CLOCK PHASE]
You can adjust the image to achieve an optimal image when there is a ickering image or smeared outlines.
1) Press as to select [CLOCK PHASE].
2) Press qw or the <ENTER> button.
f The [CLOCK PHASE] individual adjustment screen is displayed.
3) Press qw to adjust.
f Adjustment value will change between [0] and [+31]. Adjust the image so that the amount of interference is
at a minimum.
Note
f Adjustment may not be possible depending on the signal.
f There may be no optimal value if the output from the input computer is unstable.
f There may be no optimal value when the total dot number is shifted.
f [CLOCK PHASE] can be adjusted only when the YC
B
C
R
/YP
B
P
R
signal or the analogRGB signal is input to the <RGB 1 IN> terminal or the
<RGB 2 IN> terminal.
f [CLOCK PHASE] cannot be adjusted when a digital signal is input.
f The adjustment value will change to [0] when w is pressed while it was at [+31]. Also, the adjustment value will change to [+31] when q is
pressed while it was at [0].
[REALTIME KEYSTONE]
The keystone distortion that occurs when the projector is installed tilted is adjusted automatically.
1) Press as to select [REALTIME KEYSTONE].
2) Press qw to select the item to adjust.
[OFF]
The real-time keystone distortion correction function is not executed automatically.
[ON]
The real-time keystone distortion correction function is executed automatically.
Note
f The keystone distortion may not be corrected fully depending on the installation condition. In such case, adjust it with the [POSITION] menu
→ [SCREEN ADJUSTMENT].
f [REALTIME KEYSTONE] cannot be set in following cases.
g When the [PROJECTOR SETUP] menu → [PROJECTION METHOD] → [FLOOR/CEILING] is set to [CEILING]