Panasonic PT-MZ770

Chapter 7 Appendix — Technical information
222 - ENGLISH
Compatible
signal
Resolution
(Dots)
Scanning freq.
Dot
clock
freq.
(MHz)
Format
Plug and play
*1
Horizontal
(kHz)
Vertical
(Hz)
RGB
HDMI DIGITAL LINK
4K/60P 4K/30P 2K 4K/60P 4K/30P 2K
1920 x 1200/60
1 920 x 1 200
*4
74.0 60.0 154.0 R/H/DL
l
*6
l
*6
l
*6
l
*6
l
*6
l
*6
l
*6
1 920 x 1 200
*5
74.6 59.9 193.3 R ― ― ― ― ― ― ―
*1 Signal with l in the plug and play column is a signal described in the EDID (extended display identication data) of the projector. The signal that
does not have l in the plug and play column can also be input if it is described in the format column. The resolution may not be selected in the
computer even if the projector is compatible for the signal that does not have l in the plug and play column.
*2 Pixel-Repetition signal (dot clock frequency 27.0 MHz) only
*3 Only for PT-MW730
*4 VESA CVT-RB (Reduced Blanking)-compliant
*5 Samples the pixels in the image processing circuit and projects the image.
*6 Only for PT-MZ770
*7 The signal with 1/1.001x vertical scanning frequency is also supported.
*8 YP
B
P
R
4:2:0 format only
Note
f A signal with a different resolution is converted to the number of display dots. The number of display dots is as follows.
g PT-MZ770: 1 920 x 1 200
g PT-MW730: 1 280 x 800
f The “i” at the end of the resolution indicates an interlaced signal.
f When interlaced signals are connected, ickering may occur on the projected image.
f Even if it is the signal listed in the list of compatible signals, it may not be displayed by the projector if the video signal is recorded in a
special format.