Panasonic PT-RZ690

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 143
Note
f
The [BACK COLOR] setting item is common with the following menu item.
g
The [DISPLAY OPTION] menu
→
[BACK COLOR]
f
To create and register the [USER LOGO] image, use “Logo Transfer Software”.
The software can be downloaded from the Panasonic website (https://panasonic.net/cns/projector/).
[NO SIGNAL LIGHTS-OUT]
This is a function to automatically turn off the light source of the projector when there is no input signal for specic
period. The time until the light source is turned off can be set.
1) Press
as
to select [NO SIGNAL SETTING].
2) Press the <ENTER> button.
f
The
[NO SIGNAL SETTING]
screen is displayed.
3) Press
as
to select [NO SIGNAL LIGHTS-OUT].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[DISABLE]
Disables the no signal lights-out function.
[10SEC.] - [5MIN.]
Turns off the light source when there is no input signal for the preset period.
Select [10SEC.], [20SEC.], [30SEC.], [1MIN.], [2MIN.], [3MIN.], or [5MIN.].
Note
f
The power indicator <ON (G)/STANDBY (R)> will blink green slowly while the no signal lights-out function is operating and the light source is
turned off.
f
When [NO SIGNAL LIGHTS-OUT] is set to anything other than [DISABLE], the following are the conditions to turn the light source back on
again from the condition that the light source has turned off by this function.
g
When the signal has been input
g
When on-screen display such as menu screen (OSD) or input guide, a test pattern, or a warning message is displayed
g
When the power on <
b
> button is pressed
g
When the operation to disable the shutter function (shutter: open) is performed, such as pressing the <SHUTTER> button
g
When the operating environment temperature is around 0 °C (32 °F) and the light source is forced to turn on due to warm-up
f
The no signal lights-out function is disabled in following cases.
g
When [BACK COLOR] is set to [DEFAULT LOGO] or [USER LOGO], and the Panasonic logo or the image registered by the user is
displayed in the projected image
[NO SIGNAL SHUT-OFF]
This is a function to automatically set the power of the projector to standby mode when there is no input signal for
specic period. The time before switching to standby can be set.
1) Press
as
to select [NO SIGNAL SETTING].
2) Press the <ENTER> button.
f
The
[NO SIGNAL SETTING]
screen is displayed.
3) Press
as
to select [NO SIGNAL SHUT-OFF].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[DISABLE]
Disables the no signal shut-off function.
[10MIN.] - [90MIN.]
Sets the time in increments of 10 minutes.
[INITIAL STARTUP]
Set the startup method when the <MAIN POWER> switch is set to <ON>.
1) Press
as
to select [INITIAL STARTUP].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[LAST MEMORY]
Starts up the projector in the condition before the <MAIN POWER> switch is set to <OFF>.