Panasonic PT-RZ690

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 151
[REMOTE2 MODE]
Set the <REMOTE 2 IN> terminal.
1) Press
as
to select [REMOTE2 MODE].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[DEFAULT]
Uses pin assignment of the <REMOTE 2 IN> terminal in standard setting. (
x
page 223)
[USER]
Changes the setting of the <REMOTE 2 IN> terminal.
f
Proceed to Step
3)
when [USER] is selected.
3) Press the <ENTER> button.
4) Press
as
to select one from [PIN2] to [PIN8], and press
qw
to switch the setting.
[FUNCTION BUTTON]
Set the function of the <FUNCTION> button on the remote control.
1) Press
as
to select [FUNCTION BUTTON].
2) Press the <ENTER> button.
f
The
[FUNCTION BUTTON]
screen is displayed.
3) Press
as
to select a function.
[DISABLE]
Disables the <FUNCTION> button.
[SUB MEMORY]
Displays the sub memory list. (
x
page 160)
[SYSTEM SELECTOR]
Switches the [SYSTEM SELECTOR] setting according to the input signal of the image being
projected.
f
When the input signal is anything other than the SDI input
The [PICTURE] menu
→
[SYSTEM SELECTOR] (
x
page 90)
f
When the input signal is the SDI input
The [DISPLAY OPTION] menu
→
[SDI IN]
→
[SYSTEM SELECTOR] (
x
page 118)
[SYSTEM DAYLIGHT VIEW]
Switches the [SYSTEM DAYLIGHT VIEW] setting. (
x
page 88)
[FREEZE]
Freezes the image temporarily. (
x
page 125)
[WAVEFORM MONITOR]
Displays the waveform of the input signal. (
x
page 125)
[ASPECT]
Switches the aspect ratio of the image. (
x
page 93)
[PROJECTION METHOD]
Switches the [PROJECTION METHOD] setting. (
x
page 127)
4) Press the <ENTER> button.
[STATUS]
Display the status of the projector.
1) Press
as
to select [STATUS].
2) Press the <ENTER> button.
f
The
[STATUS]
screen is displayed.
3) Press
qw
to switch the pages.
f
The page will change each time you press the button.
[PROJECTOR TYPE]
Displays the type of the projector.
[SERIAL NUMBER]
Displays the serial number of the projector.
[PROJECTOR RUNTIME]
Displays the runtime of the projector.
[LIGHT RUNTIME]
Displays the runtime of the light source 1 and the light source 2.
[CONTINUOUS LIGHTING
TIME]
Displays the elapsed time from when the light source is illuminated.
The elapsed time after the illumination of the light source can be conrmed when adjusting the focus.
The elapsed time is reset when the light source is temporarily turned off such as using the shutter
function.