Panasonic PT-RZ690

Chapter 4 Settings — [PROJECTOR SETUP] menu
144 - ENGLISH
[STANDBY]
Starts up the projector in standby.
[ON]
Starts projecting immediately.
[STARTUP INPUT SELECT]
Set the input when the projector is switched on to start projection.
1) Press
as
to select [STARTUP INPUT SELECT].
2) Press the <ENTER> button.
f
The
[STARTUP INPUT SELECT]
screen is displayed.
3) Press
asqw
to select the input, and press the <ENTER> button.
[LAST USED]
Keeps the input selected last.
[RGB1]
Sets the input to RGB1.
[RGB2]
Sets the input to RGB2.
[DVI-D]
Sets the input to DVI-D.
[HDMI]
Sets the input to HDMI.
[DIGITAL LINK]
Sets the input to DIGITAL LINK.
[SDI]
Sets the input to SDI.
[INPUT1] - [INPUT10]
*1
Sets the input to DIGITAL LINK, and switches the input of the Panasonic twisted-pair-cable transmitter
to the specied input.
*1 When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the projector, its input
name is automatically reected from [INPUT1] to [INPUT10]. When an item that does not reect the input name is selected, it will be disabled.
Note
f
When the [DISPLAY OPTION] menu
→
[BACKUP INPUT SETTING]
→
[BACKUP INPUT MODE] is set to a combination of the DVI-D input
and HDMI input, and the power is turned off with the input set to HDMI during previous use, the projection will start with the DVI-D input
even if [STARTUP INPUT SELECT] is set to [LAST USED].
[DATE AND TIME]
Set the time zone, date, and time of the built-in clock of the projector.
Setting the time zone
1) Press
as
to select [DATE AND TIME].
2) Press the <ENTER> button.
f
The
[DATE AND TIME]
screen is displayed.
3) Press
as
to select [TIME ZONE].
4) Press
qw
to switch [TIME ZONE].
Setting the date and time manually
1) Press
as
to select [DATE AND TIME].
2) Press the <ENTER> button.
f
The
[DATE AND TIME]
screen is displayed.
3) Press
as
to select [ADJUST CLOCK].
4) Press the <ENTER> button.
f
The
[ADJUST CLOCK]
screen is displayed.
5) Press
as
to select an item, and press
qw
to set the local date and time.
6) Press
as
to select [APPLY], and press the <ENTER> button.
f
The setting of the date and time will be completed.