Panasonic PT-RZ690

Chapter 6 Maintenance — Troubleshooting
ENGLISH - 207
Problems Points to be checked Page
Image output from DVI-D
of the computer does not
appear.
f
Is [EDID SELECT] in [DVI-D IN] set to [EDID3] or [EDID2:PC]? 114
f
It may improve by updating the graphic accelerator driver of the computer to the
latest version.
―
f
It may improve by performing the [EDID SELECT] setting in [DVI-D IN], and then
rebooting the computer.
114
Video from HDMI
compatible device does
not appear or it appears
jumbled.
f
Is the HDMI cable connected securely? 50
f
Turn the power of the projector and the external device off and on. ―
f
Is a signal which is not compatible with the projector being input? 225
Lens shift cannot be
adjusted.
f
Perform [LENS CALIBRATION]. 128
f
Is the Fixed-focus Lens (Model No.: ET-DLE055) attached? ―
Cannot control the
projector with Art-Net.
f
Are the connections between the twisted-pair-cable transmitter and an external
device, and between the twisted-pair-cable transmitter and projector correctly done?
―
f
Is [Art-Net SETUP] set to other than [OFF]? 172
f
Are [NET], [SUB NET], [UNIVERSE], and [START ADDRESS] set correctly? 172
The DIGITAL LINK input
image is not displayed.
f
Is the cable compatible to the condition of the projector used? 52
f
Are the connections between the twisted-pair-cable transmitter and an external
device, and between the twisted-pair-cable transmitter and projector correctly done?
―
f
Is [DIGITAL LINK MODE] set to [AUTO], [DIGITAL LINK], or [LONG REACH]? Is it
set to [ETHERNET]?
165
f
Is a signal which is not compatible with a twisted-pair-cable transmitter being input? ―
Attention
f
If problems persist even after checking the preceding points, consult your dealer.