Panasonic PT-TW340

ENGLISH - 69
[Off] Test pattern is not displayed.
[Gray scale 1]
Select a test pattern so that it is easy to make various adjustments.
[Gray scale 2]
[Gray scale 3]
[Gray scale 4]
[Color bar]
[Red]
[Green]
[Blue]
[Cross hatch]
[White]
[Black]
[Raster gray]
4) Press the <ENTER> button.
f The selected test pattern is displayed and the menu screen is disappeared.
Note
f Press the <MENU> button to display the menu screen and select [Off] in [Test pattern] when you want to cancel the Test
pattern function.
[Network]
Initializes the settings of network before using the network function.
[Network setting]
1) Press as to select [Network].
2) Press the <ENTER> button.
f The [Network] screen is displayed.
3) Press the <ENTER> button.
f The [Network setting] screen is displayed.
4) Press as to select an item, and change the setting according to the instructions.
[DHCP]
[On]: If a DHCP server exists in the network to which the projector is connected,
the IP address will automatically be acquired.
[Off]: If a DHCP server does not exist in the network to which the projector is
connected, additionally set [IP address], [Subnet] and [Gateway].
[IP address] Enter the IP address if DHCP server is not used.
[Subnet] If not using a DHCP server, enter the subnet mask.
[Gateway] Enter the gateway address if DHCP server is not used.
[DNS] Enter the DNS server address if DHCP server is not used.
5) Press as to select [Set], and press the <ENTER> button.
f The following settings are set before the projector leaves the factory.
[DHCP] Off
[IP address] 192.168.1.100
[Subnet] 255.255.255.0
[Gateway] 192.168.1.1
[DNS] 192.168.1.1
Note
f Before using the DHCP server, make sure the DHCP server is already functioning.
f Consult your network administrator regarding the IP address, Subnet and Gateway.
Chapter 4 Settings - [Expand] menu