Panasonic PT-TW340 - Network Control; Network Connections

74 - ENGLISH
Network control
Network connections
The projector has a network function, and the following operations are available from the computer using the web browser
control.
f Setting and adjustment of the projector.
f Display of the projector status.
Note
f A LAN cable is required to use the network function.
r Example of a normal network connection
AC IN
f A Web browser is required to use this function. Conrm that the Web browser can be used beforehand.
Compatible Web Browser : Internet Explorer 7.0/8.0/9.0/10.0, Safari 4.0/5.0/6.0 (Mac OS)
f Use shielded LAN cable (STP cable) that is compatible with category 5 or above.
f Use a LAN cable with length of 100 m or shorter.
r Name and function of network function parts
1 2 3
1 LAN LINK/ACT lamp (yellow)
Lights on when connected.
Blinks when transmitting/receiving data.
2 <LAN> terminal (10BASE-T/100BASE-TX)
Used to connect LAN cable here.
3 LAN 10/100 lamp (green)
Lights on when connected to the 100BASE-TX.
Attention
f When a LAN cable is directly connected to the projector, the network connection must be made indoors.
f When connecting cables to both the <HDMI IN> terminal and the <USB B (DISPLAY> terminal, it may be difcult to remove
the LAN cable which is connected to the <LAN> terminal. When removing the LAN cable from the <LAN> terminal, remove a
cable connected to the <HDMI IN> terminal or the <USB B (DISPLAY)> terminal beforehand.
Projector settings
1) Use the LAN cable (Straight) to connect the projector with computer.
2) Turn on the projector.
3) Set the [Expand] menu → [Network] → [Network setting]
f For details, refer to the [Expand] menu → [Network] (x page 69).
Note
f Please conrm with your network administrator before you connect to an existing network.
Computer
Projector
LAN cable (straight) LAN cable (straight)
Hub
Chapter 4 Settings - Network control