Panasonic PT-VMZ71

Displaying internal test pattern
(Not available for the remote control supplied with PT-VMZ51S and PT-VMZ41)
To conrm the status of the projector, six types of internal test patterns can be displayed. To display test patterns,
perform the following steps.
button
1) Press the <TEST PATTERN> button.
2) Press qw to select the test pattern.
Note
f Setting is also available from the [PROJECTOR SETUP] menu → [TEST PATTERN]. (x page 93)
f Settings of position, size, and other factors will not be reected in test patterns. Make sure to display the input signal before performing
various adjustments.
Using the status function
Display the status of the projector.
button
1) Press the <STATUS> button.
f The [STATUS] screen is displayed.
PT-VMZ71
PROJECTOR SETUP
SELECT
RETURN
ASSIGNED FUNCTION:
DISABLE
NO SIGNAL
0 H
STATUS
SIGNAL
NAME
FREQUENCY
RUNTIME
LIGHT RUNTIME
PROJECTOR
CONTINUOUS LIGHTING TIME
SERIAL NUMBER
PROJECTOR
0.00kHz/ 0.00Hz
0 H
1 H
000000000
1/2
Note
f The projector status can also be displayed using the menu operation. Refer to the [PROJECTOR SETUP] menu → [STATUS] (x page 86)
for details.
Using the ECO management function
(Not available for the remote control supplied with PT-VMZ51S and PT-VMZ41)
Display the setting screen relating to ECO management.
button
1) Press the <ECO> button.
Note
f Refer to the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] (x page 87) for details.
Using the HDMI-CEC function
Display the HDMI-CEC operation screen.
ENGLISH - 59
Chapter 3 Basic Operations - Operating with the remote control