Panasonic PT-VMZ71

Operation Adjustment Range
Press the w button.
Increases the volume.
0 ~ +63
Press the q button.
Decreases the volume.
Setting the mute status
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [MUTE].
4) Press qw to switch the item.
[OFF]
Audio is output.
[ON]
Audio is muted.
Setting the audio output during standby
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [IN STANDBY MODE].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
Disables audio output in the standby mode.
[ON]
Enables audio output in the standby mode.
Note
f When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], audio cannot be output during
standby.
f When [IN STANDBY MODE] is set to [ON], you can adjust the volume with the <VOL-> button / <VOL+> button on the remote control or the
control panel during standby.
f When [IN STANDBY MODE] is set to [ON], even [QUICK STARTUP] is set to [ON], the power indicator <ON (G)/STANDBY (R)> will not
change to a red light when the specied time set in [VALID PERIOD] elapses.
Setting the audio input from the connected device
Choose the audio input terminal for each input signal.
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select the items of [AUDIO IN SELECT] to set.
[COMPUTER1]
Set the audio output for COMPUTER1 input.
[COMPUTER2]
Set the audio output for COMPUTER2 input.
[HDMI1]
Set the audio output for HDMI1 input.
[HDMI2]
Set the audio output for HDMI2 input.
[DIGITAL LINK]
Set the audio output for DIGITAL LINK input.
[MEMORY VIEWER]
Set the audio output for MEMORY VIEWER input.
[NETWORK]
Set the audio output for NETWORK input.
4) Press qw to switch the item.
f The sub items will switch each time you press the button.
[AUDIO IN 1]
Audio connected to the <AUDIO IN 1> terminal is output during projection of image from the set input
terminal.
[AUDIO IN 2]
Audio connected to the <AUDIO IN 2> terminal is output during projection of image from the set input
terminal.
92 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu