Panasonic PT-VX41E - Page 69

Network
ENGLISH -
69
Settings
Mail with the contents shown below is sent when an error has occurred.
z
Command port set up page
J
Set the port number to be used with command control.
Click [Detailed set up] → [Command port set up].
1
Input the port number to be used with command control
2
Setting update button
1
2
=== Panasonic projector report(ERROR) ===
Projector Type : PT-VX41
Serial No : 123456789
----- check system -----
FAN [ OK ]
INTAKE AIR TEMPERATURE [ OK ]
EXHAUST AIR TEMPERATURE [ OK ]
OPTICS MODULE TEMPERATURE [ OK ]
LAMP REMAIN TIME [ OK ]
LAMP STATUS [ FAILED ]
(Error code 00 00 00 00 01 00 00 00)
Intake air temperature :[ 40 degC / 104 degF ]
Exhaust air temperature :[ 30 degC / 86 degF ]
Optics module temperature :[ 70 degC / 158 degF ]
PROJECTOR RUNTIME 600 H
LAMP ECO 500 H
LAMP NORMAL 300 H
LAMP AUTO 0 H
LAMP REMAIN 2400 H
-------- Current status ---------
MAIN VERSION 1.00
NETWORK VERSION 1.00
LAMP STATUS LAMP=ON
INPUT RGB
SIGNAL NAME XGA6
SIGNAL FREQUENCY 0.00kHz / 0.00Hz
----- Wired Network conguration -----
DHCP Client OFF
IP address 192.168.0.101
MAC address 08:20:9a:fc:00:51
----- Memo -----