f When [MIC] is set to [ON], no signal is input, AV MUTE function is on, FREEZE function is on or the POWER
MANAGEMENT function is working, the audio of MIC will be output.
[EASY SETTING]
You can set the operation when press the <EASY SETTING/CANCEL> button on the control panel.
1) Press as to select [EASY SETTING].
2) Press the <ENTER> button.
f The [EASY SETTING] screen is displayed.
3) Press as to select [FOCUS ASSIST], [SCREEN FIT] or [COLORBOARD].
[FOCUS ASSIST]
The level of focus adjustment is displayed in the color and length of the bar. It is supported the
manual adjustment through rotating the focus ring.
[SCREEN FIT]
If it detects a screen frame, the projected image is corrected to t the screen frame automatically.
If it does not detect a screen frame, the KEYSTONE starts to work automatically.
[COLORBOARD]
The color values will change automatically to reach the optimal color except for the white screen.
4) Press qw to switch the item.
f The items will switch each time you press the button.
[FOCUS ASSIST]
This function is enabled when it is set to [ON]. This function is disabled when it is set to [OFF].
[SCREEN FIT]
The image will be displayed in full screen when it is set to [FULL]. The projected image will
maintain the aspect ratio which is input when it is set to [ORIGINAL]. This function is disabled
when it is set to [OFF].
[COLORBOARD]
This function is enabled when it is set to [ON]. This function is disabled when it is set to [OFF].
Note
f For details about EASY SETTING, refer to "Adjusting the projected image via EASY SETTING function" (Æpage 45).
f If all items are set to [OFF], press the <EASY SETTING/CANCEL> button and then [KEY NOT APPLICABLE] massage will
be displayed on the screen.
[TEST PATTERN]
Displays the test pattern built-in to the projector.
Settings of position, size, and other factors will not be reected in test patterns. Make sure to display the input signal before
performing various adjustments.
1) Press as to select [TEST PATTERN].
2) Press the <ENTER> button.
f The [TEST PATTERN] screen is displayed.
3) Press qw to switch the item.
f The items will switch each time you press the button.
ALL WHITE → COLOR BARS → WHITE CROSS ON BLACK BACKGROUND → BLACK CROSS ON THE WHITE
BACKGROUND → CROSS HATCH → ALL WHITE →...
f When you press the <MENU> button or <RETURN> button, it will display the sub menu of [PROJECTOR SETUP].
Note
f The initial setting is ALL WHITE. The initial screen is CROSS HATCH if you have assigned it to the <FUNCTION> button.
[FILTER COUNTER]
This function is used to reset the lter use time and set the notication display.
1) Press as to select [FILTER COUNTER].
2) Press the <ENTER> button.
f The [FILTER COUNTER] screen is displayed.
[FILTER
COUNTER]
Displays the using time of the lter.
[TIMER]
Sets the timer when you want to display an alert message of lter replacement.
[FILTER COUNTER
RESET]
Resets the lter counter.
80 -
ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu
To Next Page
Loading...
