Precautions for use
Cautions when transporting
f When transporting the projector, hold it securely by its bottom and avoid excessive vibration and impacts. Doing so may
damage the internal parts and result in malfunctions.
f Do not transport the projector with the adjustable feet extended. Doing so may damage the adjustable feet.
Cautions when installing
rDo not set up the projector outdoors.
f The projector is designed for indoor use only.
rDo not use under the following conditions.
f Places where vibration and impacts occur such as in a car or vehicle: Doing so may damage the internal parts and result in
malfunctions.
f Near the exhaust of an air conditioner or near lights (studio lamps, etc.) where temperature changes greatly (Operating
environment
Æ
page 133): Doing so may shorten the life of the lamp or result in deformation of the outer case and
malfunctions.
f Near high-voltage power lines or near motors: Doing so may interfere with the operation of the projector.
rBe sure to ask a specialized technician when installing the product to a ceiling.
This requires an optional ceiling mount bracket.
Model No.: ET-PKV100H (for high ceilings), ET-PKV100S (for low ceilings),
ET-PKV101B (Projector Mount Bracket).
rWhen using the projector in the elevation of below 1 400 m (4 593'), make sure [HIGH
ALTITUDE MODE] is set to [OFF].
Failure to do so may shorten the life of the internal parts and result in malfunctions.
rWhen using the projector in the elevation of above 1 400 m (
4 593'
) and below 2 000 m
(6 562'), make sure [HIGH ALTITUDE MODE] is set to [HIGH1].
Failure to do so may shorten the life of the internal parts and result in malfunctions.
rWhen using the projector in the elevation of above 2 000 m (6 562') and below 2 700 m
(8 858'), make sure [HIGH ALTITUDE MODE] is set to [HIGH2].
Failure to do so may shorten the life of the internal parts and result in malfunctions.
rDo not install the projector at elevations of 2 700 m (8 858') or higher above sea level.
Failure to do so may shorten the life of the internal parts and result in malfunctions.
rDo not tilt the projector or place it on its side.
Do not tilt the projector body more than approximately ±40 degrees vertically or ±15 degrees horizontally. Over tilting may
result in shortening the life of the components.
Within 15°
Within 15°
Within 40°
Within 40°
ENGLISH
-
17
Chapter 1 Preparation - Precautions for use
To Next Page
Loading...
