Description of the memory viewer screen
The indication of icons on the memory viewer screen are as following:
Icon indicates that can move to the upper layer. Move to the upper layer when selected.
Icon indicates the lower layer of the folder. Move to the lower layer when selected.
Icon indicates that the le is a picture.
Icon indicates that the le is a video.
Icon indicates that the le is not expanded even if the extension is supported.
Rotates the picture 90° to the left.
Rotates the picture 90° to the right.
Plays at the speed of about 2 times.
Plays at the speed of about 5 times.
Plays at the speed of about 10 times.
Plays pause temporarily.
Backwards at the speed of about 2 times.
Backwards at the speed of about 5 times.
Backwards at the speed of about 10 times.
About Miracast(TM)
This function is to project the displayed images on the Miracast-certied device to the projector through the wireless LAN
connection.
Connecting with the Miracast certied-device
1) Press the <Miracast> button on the remote control.
f Switch to the [Miracast(TM)] screen, and the Miracast idle screen will display.
f Press the <INPUT SELECT> button on the control panel to switch to the [Miracast(TM)] input source.
2) Start the Miracast application of the correspondent Miracast devices and PC.
f Check the projector name (Namexxxx/Projxxxx/xxxxx) which is displayed on the Miracast idle screen, and then select
the projector name from the Miracast application of the device when you have conrmed the projector name correspond
to the name which is displayed on the screen.
f The Miracast application name and starting method differs by different devices.
f Please refer to the operation instructions of the device for the operation about Miracast application.
3) Select [OK] on the confirmation screen of the connected device.
f The conrmation screen of the connected device is displayed.
Disconnecting with the Miracast certied-device
Perform the process to cut off the Miracast applicaton of the device. And then the idle screen will be displayed.
It may take more time to display the idle screen, when using other methods to disconnect with the device such as turn off the
power of the wireless devices.
Note
f Miracast is a system that has been standardized by Wi-Fi Alliance, it is possible to display the copyright protection content
(HDCP-encrypted DVD etc.).
f When connected with Miracast, the volume can not be adjusted by pressing the <VOL-/VOL+> buttons on the remote control.
f The Miracast(TM) function is disabled when the [WIRELESS LAN] menu is set to [DISABLE].
f The character after the space will not be displayed on the Miracast-certied device when the space is used in [NAME
CHANGE].
ENGLISH
-
113
Chapter 4 Settings - [NETWORK/USB] menu
To Next Page
Loading...
