3) Use a Phillips screwdriver to loosen the three lamp unit fixing screws (×3) until they turn freely.
4) Hold the used lamp unit by its handles, and pull it gently from the projector.
Lamp unit xing screws
5) Insert the new lamp unit in correct direction. Tighten the three lamp unit fixing screws (×3) securely
with a Phillips screwdriver.
f When you experience difculty in installing the lamp unit, remove it and try again. If you use force to install the lamp
unit, the connector may be damaged.
6) Attach the lamp cover. Tighten the lamp cover fixing screw (×1) securely with a Phillips screwdriver.
f Perform Step 2) in the reverse order to attach the lamp cover.
Note
f When you replace the lamp unit with new one, the projector resets the runtime of the lamp unit automatically.
Handles
Chapter 5 Maintenance - Maintenance/replacement
102 -
ENGLISH
To Next Page
Loading...
