Panasonic PT-VX600 - [Filter Counter]; [Initialize All]

Note
f The initial setting is All white. The initial screen is Cross hatch if you have assigned it to the <FUNCTION> button.
[FILTER COUNTER]
This function is used to reset the lter use time and set the notication display.
1) Press as to select [FILTER COUNTER].
2) Press the <ENTER> button.
f The [FILTER COUNTER] screen is displayed.
[FILTER COUNTER]
Displays the using time of the lter.
[TIMER]
Sets the timer when you want to display an alert message of lter replacement.
[FILTER COUNTER RESET]
Resets the lter counter.
Setting [TIMER]
1) Press as to select [TIMER].
2) Press qw to switch the setting of the timer.
f The items will switch each time you press the button.
[OFF] → [1000 H] → [2000 H] → [3000 H] → [4000 H] → [5000 H] → [6000 H] → [7000 H]
[FILTER COUNTER RESET]
1) Press as to select [FILTER COUNTER RESET].
2) Press the <ENTER> button.
f The [FILTER COUNTER RESET] screen is displayed.
3) Press qw to select [OK] and then press the <ENTER> button.
[INITIALIZE ALL]
Return various setting values to their factory default settings.
1) Press as to select [INITIALIZE ALL].
2) Press the <ENTER> button.
f The [INITIALIZE ALL] screen is displayed.
3) Press qw to select [OK] and then press the <ENTER> button.
f The [POWER OFF.] screen is displayed.
4) Press the <ENTER> button.
f The operation is disabled except for turning off the power.
Note
f The projector will enter into the standby status to reect the setting values when [INITIALIZE ALL] is executed.
f When [INITIALIZE ALL] is executed, [EMULATE] and the setting values of [NETWORK] cannot be returned to the
factory default values. For details about the initialization of [NETWORK], please refer to [NETWORK] → [INITIALIZE].
(x page 81)
Chapter 4 Settings - [PROJECTOR SETUP] menu
76 - ENGLISH