Powering on/off the projector
Connecting the power cord
Make sure that the supplied power cord is securely xed to the projector body to prevent it from being removed easily.
For details of power cord handling, refer to “Read this rst!”. (x page 2)
Attaching
1)
Check the shapes of the <AC IN> terminal on the back of the projector body and the power cord
connector and insert the plug completely in the correct direction (until you hear the side tabs click in
place).
Removing
1) Confirm that the projector is in standby mode, and remove the power plug from the outlet.
2)
Remove the power cord connector from the <AC IN> terminal of the projector body while pressing the
side tabs.
Power indicator
Displays the status of the power. Check the <ON (G)/STANDBY (R)> status of the power indicator before operating the
projector.
Power indicator <ON (G)/STANDBY (R)>
Indicator status Status
Off The power cord is unplugged.
Red
Lighting
The power is switched off (in standby mode). The
[ECO MANAGEMENT] x
[STANDBY MODE]
is set to [ECO].
Blinking
*1
The power is switched off (in standby mode). The
[ECO MANAGEMENT] x
[STANDBY MODE]
is set to [NORMAL].
Orange Lighting
The projector is cooling down.
The power is switched off after a while. (Changes to the standby mode.)
Green
Lighting Projecting.
Blinking
*2
The power is on and the lamp is not working. The [ECO MANAGEMENT]
x
[POWER
MANAGEMENT] is set to [READY].
Blinking
*3
The lamp starts work. The projector will project image after a while.
*1 The indicator will light as the following order:
2.75 seconds (light) → 0.25 seconds (off)
Chapter 3 Basic Operations - Powering on/off the projector
ENGLISH
-
35
To Next Page
Loading...
