Note
f [Name □□□□] (□□□□ is 4-digit number) is set before the projector leaves the factory.
[NETWORK CONTROL]
Set when you want to control the projector from a computer connected to the network.
1) Press as to select [NETWORK CONTROL].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
This function is disabled.
[ON]
This function is enabled. WEB control, PJLink control, the command control of the LAN are
enabled.
[AMX D. D.]
Set to [ON] to control with the controller of AMX Corporation.
Setting this function to [ON] enables detection through “AMX Device Discovery”. For details, refer to the website of AMX
Corporation.
URL http://www.amx.com/
1) Press as to select [AMX D. D.].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
This function is disabled.
[ON]
This function is enabled.
[Crestron Connected(TM)]
Set to [ON] to control with Crestron Connected™ of Crestron Electronics, Inc.
1) Press as to select [Crestron Connected(TM)].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
This function is disabled.
[ON]
This function is enabled.
[STATUS]
Displays the current network status.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The [STATUS] screen is displayed.
[DHCP]
Displays the usage state of the DHCP server.
[IP ADDRESS]
Displays the IP address.
[SUBNET MASK]
Displays the subnet mask.
[DEFAULT GATEWAY]
Displays the default gateway.
[DNS1]
Displays the address of the primary DNS server.
[DNS2]
Displays the address of the secondary DNS server.
[MAC ADDRESS]
Displays the MAC address.
[INITIALIZE]
This function is used to return various setting values of [NETWORK] to the factory default value.
1) Press as to select [INITIALIZE].
2) Press the <ENTER> button.
f The [INITIALIZE] screen is displayed.
3) Press qw to select [OK] and then press the <ENTER> button.
Chapter 4 Settings - [NETWORK] menu
ENGLISH
-
81
To Next Page
Loading...
