Replacement
Before replacing the unit
Turn off the POWER switch of the projector in proper way and disconnect the power plug from the wall outlet.
z
(
Æ
pages 38, 40)
Be sure to observe the procedure “Powering off the projector”
z
(
Æ
page 40) when performing power supply
operation.
Replacing the unit
J
ACF (Auto Cleaning Filter) unit
ACF unit is an optional accessory.
You can check the remaining amount of the ACF unit in [REMAINING FILTER] of [STATUS] in PROJECTOR
SETUP menu. (
Æ
page 83)
Contact an Authorized Service Center to purchase a Replacement lter unit (ET-ACF310).
z
J
Procedure of ACF unit replacement
Loosen “ACF cover xing screw” (1 1 )
screw) until the screws turn freely and
remove the “ACF cover”.
Slide out the “ACF unit” from the 2 )
projector slowly.
When you replace the “ACF unit”, clean the
z
compartment and/or the air exhaust port if you
need to.
Insert the new “ACF unit” into the 3 )
compartment in correct direction and
slightly push until it clicks.
Attach the “ACF cover” and tighten 4 )
“ACF cover xing screw” (1 screw)
securely.
Select [FILTER COUNTER RESET] 5 )
in [PROJECTOR SETUP] menu, and
press <ENTER> button. (
Æ
page 85)
Press ◄► to select [OK], and press 6 )
<ENTER> button.
Note
When the ACF unit is not installed, the lter indicator will
z
blink in red and the power will turn off in 10 minutes. (The
time before the power is turned off is indicated by the unit
of 1 minute.)
The replacement timing of the ACF depends on
z
environment of usage.
When resetting is performed, the lter will be wound.
z
The part numbers of accessories and separately sold
z
components are subject to change without notice.
Always install the ACF unit when using the projector.
z
Attention
When installing the ACF unit, take care not to touch the
z
lter surface.
Be sure to install the ACF unit when using the projector.
z
The ACF unit to be replaced should be an unused
z
product.
ACF cover
ACF cover xing screw
ACF unit
CANCELOK
EXECUTE
CHANGE
[ENTER]
RESET FILTER COUNTER?
To Next Page
Loading...
