Press ▲▼ to select [INTERLOCKED].3 )
Press ◄► to switch [INTERLOCKED].4 )
OFF
The [VERTICAL] and
[HORIZONTAL] settings are used
as the vertical and horizontal zoom
ratios respectively.
ON
The zoom ratio is set to the [BOTH]
setting.
This allows the pictures to be
zoomed at equal vertical and
horizontal ratios.
Note
When [ASPECT] is set to [THROUGH], [ZOOM] will not
z
appear.
When other than [DEFAULT] is selected for [ASPECT],
z
the [MODE] selection setting will not appear.
CLOCK PHASE
Clock phase adjustment achieves the best image
when the screen ickers or halos are observed around
contours.
Press ▲▼ to select [CLOCK PHASE].1 )
Press ◄► or <ENTER> button.2 )
The [CLOCK PHASE] individual adjustment
z
screen will be displayed.
Press ◄► to adjust the level.3 )
The value changes from 0 to 63. Adjust so that
z
the amount of interference is at a minimum.
Note
The CLOCK PHASE may not be adjusted, depending on
z
the signal.
No optimal value may be obtained if the output of the PC
z
to which the signal input is applied is unstable.
No optimal value may be obtained if the total number of
z
dots is not correct.
The [CLOCK PHASE] can be adjusted only when RGB
z
signal input is applied with RGB1 and RGB2 IN.
GEOMETRY
(PT-DZ8700/PT-DS8500 only)
Square video can be projected onto a special shaped
screen using unique image processing technology.
Press ▲▼ to select [GEOMETRY].1 )
Press ◄► to switch [GEOMETRY].2 )
The setting will change as follows each time
z
◄► is pressed.
OFF KEYSTONE
PC CURVED
OFF
Geometry correction is not
performed.
KEYSTONE
This adjusts projected images when
they are distorted to a trapezoid.
CURVED
This adjusts projected images
when they are distorted to a curved
surface.
PC
Û
This is for performing geometry
correction from a computer.
GEOMETRY adjustment should be carried out by :
Û
a person who is familiar with the projector or by
a service person because a high level of skill is
required to make successful adjustment.
Select [KEYSTONE] or [CURVED] in 3 )
Step 2), and press <ENTER> button.
The [GEOMETRY : KEYSTONE] or
z
[GEOMETRY : CURVED] screen will be
displayed.
Press ▲▼ to select the desired 4 )
adjustment item, and press ◄► to
adjust the correction amount.
You can adjust the projection images as shown
z
below.
To Next Page
Loading...
