Basic operations using the remote control
48
- ENGLISH
Basic Operation
Changing the picture aspect
ratio
You can toggle through an appropriate set of aspect
ratios for a given input signal.
button
Press <ASPECT> button on the remote
control.
The setting will change as follows each time
z
<ASPECT> button is pressed.
VID AUTO
*1
DEFAULT
S1 AUTO
*3
VID AUTO
(PRI.)
*3
AUTO
*2
THROUGH
HV FIT
16 : 9
V FIT H FIT 4 : 3
VIDEO/S-VIDEO (NTSC) only*1 :
RGB1/RGB2 (480i, 480p) only*2 :
S-VIDEO (NTSC) only*3 :
Note
Some aspect ratios may not be available for selection
z
depending on the input signal.
Refer to “ASPECT” of “POSITION menu” (
Æ
page 58) for
details.
To Next Page
Loading...
