SECURITY menu
See “Navigating through the menu”
z
(
Æ
page 49).
See “MAIN MENU” and “SUB MENU”
z
(
Æ
page 50).
When you apply to the [SECURITY] menu
z
before you change the password to your original,
perform to input the following factory default
password operation.
Press ▲►▼◄▲►▼◄ and <ENTER> button.
Attention
When you apply to the SECURITY menu after you
z
change the password to your original in the [SECURITY
PASSWORD CHANGE] menu, input the original
password operation.
Note
Only asterisks * will appear on the screen to represent
z
the actual characters of the password when the password
is entered.
SECURITY PASSWORD
The [SECURITY PASSWORD] screen can be
displayed when the power has been turned on. If the
correct password is not entered, operations other
than using <STANDBY (
)> button and <SHUTTER>
button and adjusting the lens will not be possible.
Press ▲▼ to select [SECURITY 1 )
PASSWORD].
Press ◄► to switch [SECURITY 2 )
PASSWORD].
The setting will change as follows each time
z
◄► is pressed.
OFF ON
OFF Deactive
ON Active
Note
[PASSWORD] is set to [OFF] by default and when
z
initialized.
Change the SECURITY PASSWORD regularly and make
z
it uneasy to guess.
The security password becomes valid when setting of
z
the security password is turned [ON] and then the MAIN
POWER switch is turned off.
SECURITY PASSWORD
CHANGE
The password can be changed.
Press ▲▼ to select [SECURITY 1 )
PASSWORD CHANGE].
Press <ENTER> button.2 )
The [SECURITY PASSWORD CHANGE]
z
screen will be displayed.
Press ▲▼◄► and numeral keys to 3 )
set the password.
Up to 8 buttons can be set as the password.
z
Press <ENTER> button.4 )
For the purposes of conrmation, 5 )
enter the password again.
Press <ENTER> button.6 )
Note
Only asterisks * will appear on the screen to represent
z
the actual characters of the password when the password
is entered.
If the password input second does not match with the
z
password input rst, an error message is displayed. In
this case, input the correct password again.
When numerals are used in the SECURITY PASSWORD,
z
initialization of the security password will be necessary if
the remote control is lost. For the method of initialization,
consult your dealer.
To Next Page
Loading...
