Recording Mode
40
AUTO:
AGC is activated, and the recording level is
adjusted automatically.
MNL (AGC):
The desired recording level can be set. AGC
will also be activated to reduce the amount of
distortion in the audio.
MNL (NO-AGC):
AGC is not activated and so natural recording
can be performed. Adjust in such a way that
the sound will not be distorted at the maximum
volume level. When the Zoom Microphone
Function is set to [ON], adjust the recording
level after pushing the [W/T] Lever toward [T].
3 Press the [5] Button (18) or [6] Button
(21) to increase or decrease the bars of the
[GAIN] Indication.
≥Adjust the [GAIN] value so that the last three
Bars of the [LEVEL (MIC)] will not light red.
(Otherwise, the Sound will be distorted.)
ª Bass Enhancer
It strengthens the lower area of the audio to
record more powerful audio.
1 Set [TAPE RECORDING MENU] >>
[ADVANCED] >> [BASS ENHANCE] >>
[3dB] or [6dB].
To Cancel the Bass Enhancer Function
Set [TAPE RECORDING MENU] >>
[ADVANCED] >> [BASS ENHANCE] >> [0dB].
ª Color Bar
This Camcorder displays a color bar chart which
is useful for adjusting the picture quality of the TV
or external monitor.
1 Set [TAPE RECORDING MENU] >>
[ADVANCED] >> [COLOR BAR] >> [ON].
≥The color bars are not recorded onto the card.
≥For other notes concerning this item, see
-78-.
;/∫:SELECT &/%:SETUP
!/MENU:EXIT
MIC LEVEL SETUP
(dB)-30 0 +6
|||||||||-----
GAIN
(dB)-30 0 +6
LEVEL
(MIC)
.............
MODE AUTO
1MNL(AGC)
MNL(NO-AGC)
MENU
STILL
FADE
ENTER
(16)
MENU
STILL
FADE
ENTER
(16)
Using the Auto Pop-up Flash
The Auto Pop-up Flash enables you to record still
pictures in a dark place.
1 Repeatedly press the [ß] Button (8) to
select a desired flash mode.
1) Auto: The Camcorder perceives the
brightness around the subject and the
Auto Pop-up Flash is automatically
popped up and activated. (In bright
places, the indication disappears and
the Auto pop-up Flash does not light.)
2) OFF: The Auto Pop-up Flash is not popped
up and activated.
3) ON: The Auto Pop-up Flash is always
popped up and activated.
2 Press the [PHOTO SHOT] Button (52)
halfway to pop up the Flash.
≥The Auto Pop-up Flash is not activated
depending on the setting on the flash and the
brightness around the subject.
3 Press the [PHOTO SHOT] Button (52) fully
which is already pressed halfway.
≥The flash lights and a still picture is recorded.
≥After recording, close the Auto Pop-up Flash
by pressing on it.
To Activate the Auto Pop-up Flash with the
[STILL] Button
If you press the [STILL] Button (17) in Step 2, the
image becomes still. (It is canceled when you
press the [STILL] Button again.)
Record your favourite scene.
(8)
1) 2) 3)
PHOTO
SHOT
(52)
PV-GS400Eng.book 40 ページ ２００４年６月４日 金曜日 午後３時１７分
To Next Page
Loading...
