Panasonic PV-GS400 - Notes and Hints

Others
74
CAN NOT OPERATE
(AE LOCK MODE):
You are attempting to press the
[ADVANCED MAGICPIX] Button with
setting the [AUTO/MANUAL/AE LOCK]
Switch to [AE LOCK].
UNABLE TO WRITE
(WIDE/PRO CINEMA MODE):
You are attempting to press the
[PHOTO SHOT] Button with setting the
Wide/Pro-Cinema Function in Tape
Recording Mode.
CHANGE TO 640k480:
You are attempting to use the function to
record still pictures which is not available
unless the [PICTURE SIZE] is set to
[640k480].
PRINTER ERROR:
Check the connected printer.
THERE IS NO INK:
There is no ink. Check the connected
printer.
THERE IS NO PAPER
There is no paper. Check the connected
printer.
Notes and Hints
ª Concerning the Power Supply
≥When the Camcorder is used for a long time,
the Camera body becomes warm, but this is not
a malfunction.
≥If the [CHARGE] Lamp does not light up
although the Battery is attached to the AC
Adaptor, detach the Battery and reattach it.
ª Inserting/Removing the Cassette
≥In the case of using a previously recorded
Cassette, you can use the Blank Search
Function to find the position where you want to
continue recording.
≥If a new Cassette is inserted, rewind to the
beginning of the tape before starting recording.
≥When inserting the cassette, make sure it faces
in the right direction and then push it in until it
stops.
≥When the Cassette Holder is in action, do not
touch anything except the [PUSH] mark.
≥When closing the Cassette Compartment
Cover, do not get anything caught in the cover,
such as a cable of the Magic Wire Remote
Control with Narration Mic.
ª Alarm Sounds
When [BEEP SOUND] on the [INITIAL]
Sub-Menu on the [TAPE RECORDING MENU] or
the [TAPE PLAYBACK MENU] is set to [ON],
confirmation/alarm beeps are issued as follows.
1 Beep
≥When you start recording
≥When you switch the [OFF/ON] Switch from
[OFF] to [ON]
2 Beeps
≥When you pause recording
2 Beeps 4 times
≥If you perform a wrong operation before or
during recording.
ª Recording Check
≥For Recording Check, the recording speed
mode (SP/LP) must be the same as the mode
used for the recording. If different, playback
images will be distorted.
ª Frame Moving Pictures (Frame Mode)
≥It is not possible to use the digital modes of
[EFFECT1]. (
-41-)
≥Set [REC MODE] to [NORMAL] for regular
recording.
≥When the [PICTURE SIZE] is set to
[1280k960], you cannot set to the Frame Mode.
PV-GS400Eng.book 74 ページ ２００４年６月４日 金曜日 午後３時１７分