Panasonic PV-GS400 - Editing Mode; Recording Tape Scenes to Card; Audio Dubbing Function

Editing Mode
53
Editing Mode
Recording from a Tape onto a Card
Still pictures can be recorded on a Memory Card
from scenes that have already been recorded on
a cassette.
1 Set the Mode Dial (44) to Tape Playback
Mode.
2 Start playback and set the Camcorder to
Still Playback Mode at the scene you wish
to record, and press the [PHOTO SHOT]
Button
(52).
Audio Dubbing
You can add music or narration to the recorded
Cassette.
≥If a tape recorded in the [16bit] Mode is dubbed
with the Audio Dubbing function, the original
sound is erased. (If you wish to preserve the
original sound, use the [12bit] Mode when
recording.)
≥Audio Dubbing cannot be performed on a
recording made in LP Mode. (
-26-)
1 Set [TAPE PLAYBACK MENU] >>
[AV IN/OUT] >> [AV JACK] >> [IN/OUT].
2 Next, select [A.DUB INPUT] >> [MIC] or
[AV IN].
≥Set to [AV IN] when an external device is
used, and to [MIC] when an external or
built-in microphone is used.
PC
S
D
(44)
PHOTO
SHOT
(52)
MENU
STILL
FADE
ENTER
(16)
3 Press the [;] Button (81) on the Remote
Controller where you want to add new
sound.
4 Press the [A.DUB] Button (67) on the
Remote Controller.
5 To start Audio Dubbing, press the [;]
Button
(81) on the Remote Controller.
To Cancel Audio Dubbing
Press the [;] Button (81) on the Remote
Controller.
The Camcorder is in the Still Playback Mode
again.
To Play Back the Sound Recorded by 12bit
Audio Dubbing
Set [TAPE PLAYBACK MENU] >> [PLAYBACK]
>> [12bit AUDIO] >> [ST2] or [MIX].
ST1: It plays back only the original sound.
ST2: It plays back only the sound added by Audio
Dubbing.
MIX: It plays back both the original sound and the
sound added by Audio Dubbing
simultaneously.
To Dub Audio While Listening to a
Pre-recorded Sound
When pausing the audio dubbing, set the
[12bit AUDIO] on the [PLAYBACK] Sub-Menu to
[ST2] and you can check the pre-recorded sound.
When a microphone is used for audio dubbing,
use headphones to listen to the pre-recorded
sound while dubbing the audio. (When using
headphones, set [AV JACK] to [OUT/PHONES].)
When the line input is used, you can dub audio
while listening to the pre-recorded sound from the
speaker.
≥For other notes concerning this item, see
-81-.
INDEX INDEX
SELECT
STOP
KL
∫
V
/REW
STILL ADV
T
W
sVOL r
¥REC
MULTI/
P-IN-P
A.DUB
PLAY
PAU SE
FF/
W
STILL ADV
61 5
;
ED
P.B. ZOOM
(67)
(81)
PV-GS400Eng.book 53 ページ ２００４年６月４日 金曜日 午後３時１７分