1
1-11-70
● Details of parts
● Procedure for attaching the parts
Parts mounted on ceiling panels
Part
name
Shape
No. of
parts
Insulator Insulator Insulator Insulator Insulator Insulator
Fig. 1-11-15 Fig. 1-11-16
Fig. 1-11-17
1. Remove the covers in the four corners. (Fig. 1-11-15)
2. Fit the ceiling panel to the indoor unit.
(For details on how the ceiling panel is to be fitted, refer to the installation instructions which are provided with the
ceiling panel.)
3. Fit the insulators <11> to <13> onto the four corners of the ceiling panel exactly as shown in Fig. 1-11-16.
4. Fit the cover in place. The cover can fall off in this state so be absolutely sure to secure it in place using the fixing screws.
<When mounting the parts onto the receivers (Fig. 1-11-17)>
For Wireless remote controller receiver For ECONAVI panel
Slit
Slit
Slit Slit
Slit
Perforations PerforationsPerforations
1
2
1
3
<12>
<11>
<11>
<13>
Cover
Drain piping
side
Datum for
attaching the parts
Datum for
attaching the parts
Used to block the square
hole of the <15> insulator
Insulator that has been
cut out along its perforations
Refrigerant
piping side
<15>
<16>
<11>
<14>
<12><13>
3
2
1
(Receiver used for
ECONAVI)
(Receiver used for
wireless remote controller)
2 2
<11> <12> <13> <14> <15> <16>
1 1 1 1
These precautions must be observed without fail.
WARNING
● Before proceeding with the installation work, please read carefully through the installation instructions which are provided with the
indoor unit and also through the installation instructions which you are now reading. In particular, be absolutely sure to read through
the “Safety Precautions” prior to installation. Also ensure that the user keeps these installation instructions in a safe place for future
reference.
■ They describe the instructions using categories which are classified by the extent of the injuries and/or damage caused by incorrect
or improper acts.
■ The actions which must or must not be taken are described using the following pictographs.
■ Panasonic disclaims all liability for any accidents or damages occurring as a result of installing the kit using any procedures
which are not described in the installation instructions or which do not use the specified parts.Any malfunctioning or trouble
caused by the manner in which the kit was installed will not be covered by the terms and conditions of the product warranty.
■ Usage precautions
• Install this insulator kit before proceeding to install the indoor unit.
• Keep these installation instructions in a safe place together with the operating instructions of the indoor unit.
■ The installation work should be entrusted to the dealer or the store where
the kit was purchased or to a specialized contractor, and the kit must be
installed correctly using only the specified parts without fail.
(Failure to follow these instructions may cause the unit to fall down and/or water to leak.)
■ The kit must be installed correctly in a location which is strong enough to
bear the weight of all the parts.
(Failure to follow this instruction may result in injuries caused by the unit falling down.)
■ The parts specified by Panasonic must be used as the accessory parts.
(Failure to use the specified parts may cause the unit to fall down and/or water to leak.)
■ The kit must not be installed in a location where flammable gases may
leak in the area around it.
(Failure to follow this instruction may cause ignition if gas should leak and accumulate in the area around
the unit.)
These precautions describe instructions which must be followed in order to avoid personal injuries and/or property damage.
This indicates an action which must not
be taken (that is, an action which is prohibited).
This indicates an action which must be taken
(that is, an action which is mandatory).
CAUTION
Insulator that has been cut out
along its perforations
Cut out along the perforations the insulators <11>, <12> and/or <13> that fit the mounting location, mount them by matching
them to the shape of each receiver, and attach the covers to the ceiling panel.
* Be absolutely sure to use the maximum dimensions of 910 mm x 910 mm for the extent of the ceiling opening so that the
ceiling surface and insulators will not absorb any shocks.
(For details on how the ceiling panel is to be fitted, refer to the installation instructions which are provided with the
ceiling panel.)
Applicable indoor units:4-Way Cassette
INSTALLATION INSTRUCTIONS
Thermal insulation kit
Model No.CZ-INSU3
Safety Precautions
This symbol refers to a hazard or
unsafe practice which can result in
severe personal injury or death.
This symbol refers to a hazard or
unsafe practice which can result in
personal injury or product or property
damage.
85464369938001
Printed in JAPAN PA0816-10816
CV6233336251
WARNING
CAUTION
NOTES
SM830266-00_大洋州向けR32シングルTD&SM.indb 70 18/03/29 10:20:57
To Next Page
Loading...
